TurboCAD Forums

The Ultimate Resource for TurboCAD Knowledge

Register
 
Be sure your post is relevant to the current discussion.  Create a new topic within the appropriate board if you are unsure.

When user creates an offset of "spline", offset of spline replaces with "Bezier
Read 1375 times
September 27, 2017, 11:14:40 AM
Please see the attached image.

Reason:
Several configurations of splines can be converted in beziers when offsetting. In some cases offset can also consist of several parts of curves/beziers.

Logged
Thanks & Regards,
Zunair Attif
Manager QA\Support
IMSI Design
Email: zattif@imsidesign.com
Skype: zattif@imsitechnologies.com


* September 27, 2017, 01:34:44 PM
#1
It depends on which version is being used as to what will be generated by the Offset tool.

There was a chart in the now-defunct TurboCAD Community site showing who-got-what, but that information is most likely gone to the scrap heap.

Logged
John R.

V17—V21, 2015—2019
Designer, Deluxe, (Professional, Expert, Basic), Platinum
RedSDK enabled
Windows 10 Pro (1803), 64-bit


* September 27, 2017, 06:11:47 PM
#2
It depends on which version is being used as to what will be generated by the Offset tool.

There was a chart in the now-defunct TurboCAD Community site showing who-got-what, but that information is most likely gone to the scrap heap.

RE:  "the now-defunct TurboCAD Community site showing who-got-what, but that information is most likely gone to the scrap heap."

What a terrible waste of a lot effort and informative and useful information if IMSI/Design did in fact allow the TurboCAD Community site (TurboCAD Wiki site) to die off.

Logged
Alvin Gregorio
(mostly Residential Architectural 2D; no formal CAD Training; intermittent TurboCAD user since yr. 2000 [ver6.5])
---TurboCAD: V20.2PP(57.0)[as of 3/12/15]; V19DL(54.2); V11.2Pro; Windows-7-Pro/64-bit; Intel-Core-i3 CPU; 2.27ghz; 4GB RAM; Intel HD Graphics (CPU based)