TurboCAD Forums

The Ultimate Resource for TurboCAD Knowledge

When posting a problem be sure to include which version you are using.  Give as much information as possible.  If the problem is with a specific file be sure to attache it to your post.

In image manager you can only load an object you can't drag it into drawing area
Read 1254 times
September 27, 2017, 11:02:31 AM
To insert image into drawing use Insert->Picture->From Image List.

Thanks & Regards,
Zunair Attif
Manager QA\Support
IMSI Design
Email: zattif@imsidesign.com
Skype: zattif@imsitechnologies.com

* September 27, 2017, 01:26:27 PM
You can drag an image into the drawing from the new "Image Manager Palette", provided there is an image present in the list. As you're dragging, you will have to define either its "Width, Height or PPI" first in the Inspector Bar, then place it into the drawing. It uses the center of extents of the image as the placement point.

Otherwise, use the "Insert" option in the previously mentioned "Insert / Picture / From Image List"…
or use "Insert / Picture / From File". These two options use the "upper-left" to "bottom-right" as insertion points.

John R.

V17—V21, 2015—2020
Designer, Deluxe, (Basic, Expert, Professional), Platinum
RedSDK enabled
Windows 10 Pro (1909), 64-bit