Try this Procedure. This was done in TC21Pro. Build 71
thanks for the wonderful illustration. Very useful.
However I am doing something wrong here. I have created tube bend with the same properities as in your example, yet I get different bend (as shown on attached animation). When selecting Tube bend tool, I can't simply enter values into the inspector bar and press Enter. I must click on the part itself and that messes something up. Very confusing
I've figured out. Because of some reason, the axial distance in the middle part (cylinder) was measured from the top, not from the bottom as in the right bent tube. So I should enter 87,123 (total length of cylinder) - 30 (which is the lower unbent part).
By the way, could you tell how have you set up this color scheme, with black background and white lines, it is very pleasing to the eyes? Figured out as well, Options-Background Color.
Thanks again for the assistance.
« Last Edit: July 14, 2017, 02:45:56 PM by tarmiricmi »
Windows 10 64bit
TC 2016 Pro 64bit, RedSDK
Lenovo M92p I5 3550 8GB RAM NVIDIA GForce GTX 1050ti 4GB