TurboCAD Forums

The Ultimate Resource for TurboCAD Knowledge

When posting a problem be sure to include which version you are using.  Give as much information as possible.  If the problem is with a specific file be sure to attache it to your post.

Work planes V11.2
Read 1790 times
* October 07, 2009, 12:28:24 AM
V11.2 pro, have not tried this in 16.1 yet.
Recently imported a dwg (2d plan) file to find that it was not all on the same work plane. Placing lesser enitites in the right place in 3d select mode all looked right and well.
Selected all and placed on the work plane and everything went back as it was.

Is there a way to place enitities on work plane they were not created on?

Thanks in anticipation

Steve T


* October 07, 2009, 01:16:45 AM
I'm also using 11.2 Pro.
I defined an assorted collection of 2D and 3D entities at various distances from the current workplane.
I then selected them all in 3D mode, chose Format|Place on Workplane and they all ended up on the current workplane.
What did you do?

Gary Wooding
Win10 64-bit,
TC21.2 x64 Plat, Bld59
TC16.2 Plat, Bld54.0
TCC 3.5