TurboCAD Forums

The Ultimate Resource for TurboCAD Knowledge

All posts discussing pricing or where to buy TurboCAD will be deleted.

Selector properties
Read 1605 times
* October 06, 2009, 05:47:25 PM
Is it possible to set selector properties so that the selector's default position is, for example, the position of the first click of creation of the entity?  I think on balance that it would be a time saver.  Most lines I edit have transformations derived from endpoints, polygons lose reference from centre if they're odd-number-sided, not ortho, or irregular, and so on.  Boxes are created from corner points in 3D.  Is there a setting I've overlooked?  Does anyone have alternative ideas, or think that it would be useful?  

*or a SEKE selector toggle between first point and centre of extents?
« Last Edit: October 06, 2009, 05:50:59 PM by murray dickinson »