TurboCAD Forums

The Ultimate Resource for TurboCAD Knowledge

Register
 
The purpose of these forums is to discuss TurboCAD.  Please keep the discussion of other products to compatibility issues or how the other software’s can be used with TurboCAD.


Adding 2d lines on a 3d cylinder model.
Read 811 times
* June 24, 2012, 08:42:49 PM
Is there a way to add a line extended past the length of a 3d cylinder to assemble component to?Thanks.   

Logged


* June 24, 2012, 10:23:39 PM
#1
How about a 3D Polyline. Just draw one segment. Snap to your specified point on the cylinder, then X&Y=0 and Z= your specified height above the cylinder. Use the Edit Tool to move the endpoint node, if necessary, or use the "Length" parameter in the Selection Info palette (since it's only one segment).

Logged
John R.

V17—V21, 2015—2019
Designer, Deluxe, (Professional, Expert, Basic), Platinum
RedSDK enabled
Windows 10 Pro (1903), 64-bit