TurboCAD Forums

The Ultimate Resource for TurboCAD Knowledge

Register
 
When posting a problem be sure to include which version you are using.  Give as much information as possible.  If the problem is with a specific file be sure to attache it to your post.

Degenerative faceting after error message
Read 676 times
* April 02, 2012, 04:57:07 AM
Hi All, this problem is repeatable every time for me using v19 64bit (don't know wbout 32bit), so I thought I'd post it in case others can repeat it as if so then it could catch out the unwary, it took me a while to realise what was happening..

See attached . . . . . Andy

Logged