TurboCAD Forums

The Ultimate Resource for TurboCAD Knowledge

Register
 
Be sure your post is relevant to the current discussion.  Create a new topic within the appropriate board if you are unsure.

  1. TurboCAD Forums
  2. Plug-In Palace
  3. GPS 2 TurboCAD
  4. GPS to TurboCAD
Go Down
GPS to TurboCAD
Read 11376 times
Next Previous
May 15, 2009, 02:55:41 PM
« Last Edit: December 27, 2015, 11:27:13 AM by John R »
Logged
Rip Fowler
IMSIDesign LLC

* May 18, 2009, 10:30:33 AM
#1
Well this looks interesting...

What Datums would you use for Mexico and Canada?

Can you shift the line of Origin for UTM  -- assuming that you have not done any particular adaptation to Canada or Mexico. If so I assume that this would be done using UTM_NORTH.



Logged
WillR
SW:TC 21 Pro Platinum, FM15, 20 Pro Platinum 64 Bit, also V 19.1 64Bit & 32 bit 17.2 and 18.1; Furniture Maker 14 and 10. HW: Vista 64 Ultimate, AMD 1090 (6 core) 8GB memory Plus also an AMD  8 core systemFX

June 03, 2009, 12:10:59 PM
#2
Sorry for the delay, the plug-in is made by a third party here is the support site.

http://www.gps2turbocad.com/Support.htm

http://www.gps2cad.com/indexSUpport.htm
« Last Edit: December 27, 2015, 11:26:00 AM by John R »
Logged
Rip Fowler
IMSIDesign LLC

Go Up

  1. TurboCAD Forums
  2. Plug-In Palace
  3. GPS 2 TurboCAD
  4. GPS to TurboCAD
 

SMF 2.0.11 | SMF © 2015, Simple Machines Smf Destek

Page created in 0.143 seconds with 23 queries.