TurboCAD Forums

The Ultimate Resource for TurboCAD Knowledge

Be sure your post is relevant to the current discussion.  Create a new topic within the appropriate board if you are unsure.

DXF files for CNC router - unjoined curves and lines
Read 6068 times
* June 12, 2009, 10:39:24 PM
hi, i'm just doing some basic 2D drawings on Turbocad Mac Pro v3 to send to a CNC router

But usually there are several lines or curves which are unjoined and the CNC operator needs to spend a lot of time point-by-point adjusting the files I send him.

I can join curves no problem. but is there a display that can tell me in TC what lines/curves are not joined?




June 13, 2009, 06:03:14 AM
Hi Malcolm,

The PC and Mac versions of TurboCAD are two completely different programs. You would probably get a better answer on the TurboCAD for Mac forum: http://tcmacforum.imsisupport.com/