TurboCAD Forums

The Ultimate Resource for TurboCAD Knowledge

When posting a problem be sure to include which version you are using.  Give as much information as possible.  If the problem is with a specific file be sure to attache it to your post.

Error when using Animation Lab
Read 2432 times
April 19, 2010, 11:49:29 AM

header is:

:System:  Unknown version of Windows based on NT, version 6.0.6000
tcw14.exe caused an EXCEPTION_ACCESS_VIOLATION in module Geom14.dll at 001B:040811CA, GHeap::Free()+0081 byte(s)"

The entire error file is attached.

The TCW drawing is also attached.

I am running TC Pro 14.2 Basic edition and Animation Lab 4 (not sure of the version and don't know how to check it) all on a Dell 32 bit Vista Home machine.

Any thoughts?


Hi Joe,

ran your file scenario in v16.2 . . with no modification or problems.

You might find that an earlier version of Animation Lab is required, or, a reinstall of TC, followed by Animation Lab.

Try asking IMSI direct, for further guidance.

I hope this helps.

Regards Tim
« Last Edit: April 20, 2010, 11:23:13 AM by Tim Stewart »

Regards Tim

You can design without engineering, but you cannot engineer without design.
Using Win 10 with Designer 2016/2017 and TurboCAD Pro. Plat. 2018/2019 + Lightworks (64-bit versions) + AnimationLab 5.2.
Windows 10 Pro (1909) 64-bit