TurboCAD Forums

The Ultimate Resource for TurboCAD Knowledge

The purpose of these forums is to discuss TurboCAD.  Please keep the discussion of other products to compatibility issues or how the other software’s can be used with TurboCAD.

"fitting" attributed text
Read 1184 times
March 15, 2010, 07:28:31 PM
I have created a drawing border/title block.  Inside the title block I have some attributed text.  In the "title" area, I would like to have my attributed text automaticaly "fit", width wise, regardless how many characters are used.  This can be done in AutoCAD, but can it be done in TurboCAD?  If so, how?