TurboCAD Forums

The Ultimate Resource for TurboCAD Knowledge

Register
 
All posts discussing pricing or where to buy TurboCAD will be deleted.

2D drawing lin thickness and laser cutting
Read 1539 times
* September 15, 2019, 06:49:45 AM
Hi,

I have a TC 10.0.5 (build 1359) for mac.

I want to draw a shape in 2D, the line thickness have to be 0,1 mm.
Assume I draw a square of 10 by 10 mm.
How is the line aligned according to the square I draw?
- Is the line inside my measurements an I end up with a square of 9.8 by 9.8 mm
- Is the line centered to my measurements an I end up with a square of 9,9 by 9,9 mm
- Is the line outside to my measurements an I end up with a square of 10 by 10 mm

What is the default behaviour ?
Is it possible to change this setting?
If it is possible how do I set this up? 

Kind Greetings,
Frank

Logged


* September 15, 2019, 06:58:50 AM
#1
I'm not sure, but believe it is calculated from center, so then it should be 99.5 x 99.5 With 1 mmed mer thickness
But TC for Mac is different then what this forum is about, so maybe you will get an better amswer at;
http://tcmacforum.imsisupport.com/

Torfinn

Logged
V20, V21, 2015/ 16/ 17/ 18/ 19 Pro. Platinum
Deluxe 2015/ 16/ 19
RedSDK enabled
Windows 10 Home Premium 64 bit, 32 GB
NVIDIA Geforce GTX 780m, 1 GB


* September 15, 2019, 07:33:14 AM
#2
Hi, Thanks, I go to the right forum.

Logged