TurboCAD Forums

The Ultimate Resource for TurboCAD Knowledge

Register
 
When posting a problem be sure to include which version you are using.  Give as much information as possible.  If the problem is with a specific file be sure to attache it to your post.

Luminance & Anilab
Read 703 times
* July 22, 2019, 05:25:08 PM
See Julian Thomas reply #10 http://forums.turbocad.com/index.php/topic,2968.0.html
Julian did not provide information on his statement, just wondering if is/are multiple luminances not suitable for anilab animations?

Logged
Daz
TCW V21, 2016-2019 PP, Animation Lab V5 & LightWorks rendering mostly.


July 24, 2019, 05:56:37 AM
#1
See Julian Thomas reply #10 http://forums.turbocad.com/index.php/topic,2968.0.html
Julian did not provide information on his statement, just wondering if is/are multiple luminances not suitable for anilab animations?

Daz,

I see no good reason why multiple luminances should not work with AnimationLab. 
You just need to experiment to get the look you're after, for each rendered image.

Regards Tim

Logged
You can design without engineering, but you cannot engineer without design.
Using Win 10 with Designer 2016/2017 and TurboCAD Pro. Plat. 2018/2019 + Lightworks (64-bit versions) + AnimationLab 5.2.


* July 24, 2019, 02:09:05 PM
#2
Tim I was just wondering why Julian made this statement, albeit that this is an old post. Based on Deans reposted image in general discussions it looks dam good.

Logged
Daz
TCW V21, 2016-2019 PP, Animation Lab V5 & LightWorks rendering mostly.


July 25, 2019, 12:32:51 AM
#3
Daz,

if I were a betting man, I would go with Dean!   ;) ;D

Regards Tim

Logged
You can design without engineering, but you cannot engineer without design.
Using Win 10 with Designer 2016/2017 and TurboCAD Pro. Plat. 2018/2019 + Lightworks (64-bit versions) + AnimationLab 5.2.