TurboCAD Forums

The Ultimate Resource for TurboCAD Knowledge

Remember to do a search before you ask a question!!!

Control C and Conrol V doesnt work properly
Read 625 times
* March 25, 2019, 07:42:37 AM
When using these commands to 'copy' and 'set the copy' of a detail to another sheet, the detail is finally copied to another sheet, but is almost blown apart into some pieces. The text and leaders will be scattered and some of the blocks (i.e. screws) are blown up with some pieces not being able to be moved or deleted. There was a lot of information already on the sheet, where I was going to transfer the detail on to. However, when I copied the same detail to a blank sheet, the detail copied fine.
Any idea what is going on?
Thank you!


March 25, 2019, 07:56:00 AM
Are you in Wireframe display mode when copying and pasting?  If not, you probably won't like what you are getting.


TC Pro Platinum 2020, 2019, 2018, 2017, 2016 & 2015 (all with LightWorks & RedSDK) & V21
System: i7-5820K @ 3.30GHz, ASRock X99 Extreme4, 16GB DDR4-2133 RAM, Gigabyte GTX 970, Samsung NVMe SSD 950 (256GB), Windows 7 Pro (64-bit) SP1

* March 25, 2019, 08:58:25 AM
Does being in that mode mean everything is displayed as a wire frame? Right now, it is not. Just displayed as normally viewed architectural details, plans, etc.


* March 25, 2019, 12:51:14 PM
You need to be in wireframe for ctrl c and v, in both drawings and also on the same workplane in both drawings.

You could Tile the 2 drawings and drag it over, after start moving press ctrl button and you will make a copy, or just close the original drawing and click no when TC ask if you want to save, that also should make a copy.


V20, V21, 2015/ 16/ 17/ 18/ 19 Pro. Platinum
Deluxe 2015/ 16/ 19
RedSDK enabled
Windows 10 Home Premium 64 bit, 32 GB
NVIDIA Geforce GTX 780m, 1 GB