TurboCAD Forums

The Ultimate Resource for TurboCAD Knowledge

Register
 
Be sure your post is relevant to the current discussion.  Create a new topic within the appropriate board if you are unsure.

saving as DXF file
Read 1783 times
* February 23, 2010, 04:56:39 PM
I can't get a arch design which I saved as a DXF file to open up in another program ( illustrator).  Keep getting the message file corrupted.  After works completed in illustrator it is going to a water jet cutting program which also suppose to accept DXF files.  Have any suggestions why a simple drawing in turbocad can't be exported?  Am able to export from illustator into Turbocad. Thanks

Logged


* February 23, 2010, 05:05:15 PM
#1
saving it as dwg,and 2000 version could change it.yes i realize you want dxf.but see if the water jet will accept dwg.usually some will read both.and if corrupt it is more likely is.When jumping around like that this happens.I seen it before.Save drawing as TCW.than another file as a dxf should work, avoid the Illustrator if possible.Than double check it Autocad Viewer.These steps work for me in the past.After I clean up the drawing.
« Last Edit: February 23, 2010, 06:44:32 PM by wd »

Logged
Even a mistake may turn out to be the one thing necessary to a worthwhile achievement Henry Ford
If I have ever made any valuable discoveries it has been owing more to patient attention than to any other talent Isaac Newton
I have not failed Ive just found 10,000 ways that won't work Thomas Edison


* February 24, 2010, 04:52:13 AM
#2
If you post the file, others may be able to give more specific assistance.

JoeM

Logged