TurboCAD Forums

The Ultimate Resource for TurboCAD Knowledge

Register
 
All posts discussing pricing or where to buy TurboCAD will be deleted.

Logi K800 Keyboard
Read 470 times
* March 06, 2019, 09:39:03 AM
Hello, it's crazy but the "ESC" key stopped working. I tried everything to no avail. So I hooked up an old wired keyboard and sun of a gun. ESC still doesn't work.  I checked TC help but not there.
Any ideas? Re-install?
Thanks - Bob

Logged
TC19, TC24, Lightworks, TC2018Deluxe, TC2018 PP + Animation Lab


* March 06, 2019, 09:52:06 AM
#1
I would go to "Tools / Customize" and "Load From" the configuration you use or click on the "Default" button. Usually this will reset the hotkeys. Otherwise, clear the "Built-In" folder; see Common troubleshooting procedures for TurboCAD.

Logged
John R.

V17—V21, 2015—2019
Designer, Deluxe, (Professional, Expert, Basic), Platinum
RedSDK enabled
Windows 10 Pro (1903), 64-bit


* March 06, 2019, 12:21:14 PM
#2
Thanks John, deleting the Buillt-In folder did the trick.

Logged
TC19, TC24, Lightworks, TC2018Deluxe, TC2018 PP + Animation Lab