TurboCAD Forums

The Ultimate Resource for TurboCAD Knowledge

Register
 
Interested in some really terrific mobile apps? Visit www.turboapps.com for details.

Animation lab 4.4 update
Read 5338 times
* February 22, 2010, 06:34:18 AM
I sent 2 x emails asking for the link to the latest update for animation lab, but still no reply.

Logged


February 22, 2010, 11:08:13 AM
#1

Hi,

you might try this link.  You will need your serial number to activate the programme.


http://support.turbocad.com/dl/confirm.php?get=AniLab-4-4.exe&pna


I hope this helps.

Regards Tim

Logged
You can design without engineering, but you cannot engineer without design.
Using Win 10 with Designer 2016/2017 and TurboCAD Pro. Plat. 2018/2019 + Lightworks (64-bit versions) + AnimationLab 5.2.


* February 22, 2010, 11:44:20 PM
#2
Thanks Tim

Logged


* February 24, 2010, 12:15:10 PM
#3
Actually, I just loaded up my previous version of Animation Lab (V4) and it doesn't seem to have a serial number. SO, when I try to load the update (v4.4), it won't allow it.

Any suggestions? I would hope that I am eligible to receive the update. when I purchased it in June 2006 it was $230, now its only $100.

Logged


February 25, 2010, 10:53:55 AM
#4
Actually, I just loaded up my previous version of Animation Lab (V4) and it doesn't seem to have a serial number. SO, when I try to load the update (v4.4), it won't allow it.

Any suggestions? I would hope that I am eligible to receive the update. when I purchased it in June 2006 it was $230, now its only $100.

Remove all old/er versions of Animation Lab, (perhaps do a registry cleanup, if you have the software), reboot, install update, enter serial number, when asked, and all should be well.

Regards Tim

Logged
You can design without engineering, but you cannot engineer without design.
Using Win 10 with Designer 2016/2017 and TurboCAD Pro. Plat. 2018/2019 + Lightworks (64-bit versions) + AnimationLab 5.2.


February 25, 2010, 11:03:42 AM
#5
You will have need to have purchased version 4.2 or above.  Otherwise you will not have a serial number, in that case contact our sales department about an upgrade.

800-833-8082 x1

Logged
Rip Fowler
IMSIDesign LLC


* February 25, 2010, 11:07:45 AM
#6
OK, that makes sense now. Thanks & wilco.

Logged