TurboCAD Forums

The Ultimate Resource for TurboCAD Knowledge

Be sure your post is relevant to the current discussion.  Create a new topic within the appropriate board if you are unsure.

Incorrect IFC export of 2D/3D block insertions
Read 454 times
* December 24, 2018, 03:02:16 AM
1-Open attached wall_w_openings.tcw file.
2-Save it to .IFC format.
3-Close that file and open saved .IFC file.
4-Openings have too large thickness.

The wall has the same extent (see Wall&Block.png ). 2D/3D blocks do not exported because the 3D part specified incorrectly.