TurboCAD Forums

The Ultimate Resource for TurboCAD Knowledge

Register
 
When posting a problem be sure to include which version you are using.  Give as much information as possible.  If the problem is with a specific file be sure to attache it to your post.

Pick Point Hatching between bezier with brush and circle
Read 687 times
* November 24, 2018, 02:13:19 AM
Pick Point Hatching doesn't work for area of intersection between bezier with brush and circle.

"Pick point hatch" tool does not take in account graphics with brush.

Logged


* November 24, 2018, 03:07:30 PM
#1
Tip - Use the hatching tools (e.g. pick point hatch) to hatch the Bezier, rather than give it a brush pattern.  this allows all areas to be hatched.

Logged