TurboCAD Forums

The Ultimate Resource for TurboCAD Knowledge

Register
 
Be sure your post is relevant to the current discussion.  Create a new topic within the appropriate board if you are unsure.

Lines disappear after converting .TCW file to .DWG format
Read 413 times
* November 17, 2018, 01:06:37 AM
DWG/DXF format does not support bitmap brushes which convert to regular brushes at export to DWG. This conversion cannot be done to get the same appearance.

Tip: Do not use bitmap brushes in TurboCAD if using of export to DWG/DXF planned.

« Last Edit: November 17, 2018, 01:10:13 AM by Shumaila Hassan IMSI »

Logged


* November 17, 2018, 01:09:19 AM
#1
Files attached

Logged