I would with go John,Henry,Jeff, recommendations after taking there suggestions to task it is the better process.I was more less jumping the gun ahead and thinking of 3d process.I always work from common zero point and position and the UCS is accordingly to the work plane. This is relevant when using the Cam end of it but of course your not doing that.For instance the UCS can be set to any side of object or in the center of the object.But I won't go into extensive detail about.Sorry about any misunderstanding on my end.
John,Henry,Jeff thanks for the clarification on matters.
Even a mistake may turn out to be the one thing necessary to a worthwhile achievement Henry Ford
If I have ever made any valuable discoveries it has been owing more to patient attention than to any other talent Isaac Newton
I have not failed Ive just found 10,000 ways that won't work Thomas Edison