TurboCAD Forums

The Ultimate Resource for TurboCAD Knowledge

Register
 
Be sure your post is relevant to the current discussion.  Create a new topic within the appropriate board if you are unsure.

  1. TurboCAD Forums
  2. Turbo Talk
  3. FAQs
  4. If a dimension is applied on object from Drafting Palette.
Go Down
If a dimension is applied on object from Drafting Palette.
Read 1019 times
Next Previous
September 27, 2017, 07:47:22 AM
A dimension that should be 28mm with a Zoom Factor of 2 will sometimes be displayed as 56mm.

Reason:
28 shown for associated dimension (this dimension knows it is attached to drafting with scale 2)
56 shown in not associated dimension, so this is just real distance between two points
Logged
Thanks & Regards,
Zunair Attif
Manager QA\Support
IMSI Design
Email: zattif@imsidesign.com
Skype: zattif@imsitechnologies.com

Go Up

  1. TurboCAD Forums
  2. Turbo Talk
  3. FAQs
  4. If a dimension is applied on object from Drafting Palette.
 

SMF 2.0.11 | SMF © 2015, Simple Machines Smf Destek

Page created in 0.358 seconds with 23 queries.