TurboCAD Forums

The Ultimate Resource for TurboCAD Knowledge

Register
 
When posting a problem be sure to include which version you are using.  Give as much information as possible.  If the problem is with a specific file be sure to attache it to your post.

Polyline does not Extrude
Read 1269 times
* May 22, 2017, 11:58:44 AM
It is most commonly reported that polyline does not extrude to create a 3D solid, rather it creates a hollow closed entity with the height as set for extrude.

This happens when the end points of a closed polyline shape are not joined properly, either there is a gap or one of the segments extends the intersections point. So, if this happens, then trim that segment and use close profile to draw a closed profile, to make sure that the end points of the polyline meet at one point.



Logged