TurboCAD Forums

The Ultimate Resource for TurboCAD Knowledge

When replying to a specific statement be sure to quote the previous post.

AL and TCv2016
Read 3173 times
* February 24, 2016, 02:05:44 PM
I published a couple of tiny tests on the general forum, but removed the post as two tiny Gif animations were taking up over 1Mb of server space, so I did a little YouTube one instead.

For anyone interested AnimatinLab appears to be working fine so far with v2016 though obviously this is with an unofficial 'cheat' as I copied the 2015 palette link into 2016 palette.


##Edit##    should mention I'm using trial version of TC v2016 - no idea if that makes any difference, not found any way to make the new Law tool work with AL yet       ##End Edit##
« Last Edit: February 24, 2016, 02:11:20 PM by Andy H »


* February 24, 2016, 02:37:56 PM
Very nice animation showing some aspects of the new tools.

John R.

V17—V21, 2015—2020
Designer, Deluxe, (Basic, Expert, Professional), Platinum
RedSDK enabled
Windows 10 Pro (1909), 64-bit

March 05, 2016, 09:57:53 AM

CREO 3 and 5
SolidWorks 2017
TC2019 Pro Platinum CADCAM
Hexagon VISI 2020.1 CADCAM
Christchurch, Middle Earth.

March 10, 2016, 05:16:28 AM
Updates, specifically for Animation Lab. with TurboCAD 2016, are now available here:


Regards Tim

Regards Tim

You can design without engineering, but you cannot engineer without design.
Using Win 10 with Designer 2017-2020 and TurboCAD Pro. Plat. 2018-2020 + Lightworks (64-bit versions) + AnimationLab 5.2.
Windows 10 Pro (1909) 64-bit