TurboCAD Forums

The Ultimate Resource for TurboCAD Knowledge

Register
 
Be sure your post is relevant to the current discussion.  Create a new topic within the appropriate board if you are unsure.

Toolbars
Read 3889 times
May 25, 2009, 12:12:37 PM
I've been using the Cadcourse tabbed toolbar set up since V11, and it has become the accustomed way for me to operate the program.  I was very happy to see that in V16 they had an option for that set up, which could be loaded directly.  Since V15, there has been an "extra" set of views, called 'dimetric' I think, that I found so useful that I incorporated them into my "pop-up" menubars, that come up when the right button is pressed. 
This morning, while trying to get the Surface Modeler toolbar activated, per Jerry's instructions, which involved choosing the V11 UI, and then going back to V16, those sets of views, dimetric SE, SW, NE, NW, seem to have vanished.  Is there any way to get them back?  Is there a file of the Cadcourse V16 posted somewhere, that I could load to get them back?  I miss them a lot, and they just are NOWHERE to be found in the standard view menus. 

Logged
Steven D. Thompson


* May 25, 2009, 01:03:05 PM
#1
re: Dimetric toolbar

The Dimetric toolbar is a user created toolbar.

John R.


Logged
John R.

V17—V21, 2015—2020
Designer, Deluxe, (Basic, Expert, Professional), Platinum
RedSDK enabled
Windows 10 Pro (1909), 64-bit


May 25, 2009, 07:20:44 PM
#2
Quote
they just are NOWHERE to be found

[attachment deleted by admin]

Logged
Julian

TC18 / 38.5 Platinum, AL5. XP, Core2 Duo E6750 OC'd 3.0Ghz, Render test: 3mins 3sec.


* May 25, 2009, 10:17:25 PM
#3
Julian,

I find at times that some tools aren't listed in those Categories areas of the V11UI, so I usually go to the [All Commands] section at the bottom. I may also consult my list of tools (in html format) prior to going to Tools / Customize. A lot easier to navigate than the list in the dialog. :-)

John R.

[attachment deleted by admin]

Logged
John R.

V17—V21, 2015—2020
Designer, Deluxe, (Basic, Expert, Professional), Platinum
RedSDK enabled
Windows 10 Pro (1909), 64-bit


May 25, 2009, 11:16:46 PM
#4
Thanks for the list John, will be very handy.

PS Congrats to being a "Full Member" ;)

Logged
Julian

TC18 / 38.5 Platinum, AL5. XP, Core2 Duo E6750 OC'd 3.0Ghz, Render test: 3mins 3sec.


* May 26, 2009, 12:42:52 AM
#5
Thanks for the list John, will be very handy.
PS Congrats to being a "Full Member" ;)

You're welcome.
"Full Member" tells me I talk too much.  ;D

John R.


Logged
John R.

V17—V21, 2015—2020
Designer, Deluxe, (Basic, Expert, Professional), Platinum
RedSDK enabled
Windows 10 Pro (1909), 64-bit