TurboCAD Forums

The Ultimate Resource for TurboCAD Knowledge

Register
 
Be sure your post is relevant to the current discussion.  Create a new topic within the appropriate board if you are unsure.

Adding/removing blocks from multiple drawings
Read 997 times
* August 31, 2015, 12:34:00 PM
I was wondering if there was a way to add and/or remove blocks from multiple turbocad drawings (100s) quickly/easily. 

Logged


* September 01, 2015, 04:20:15 PM
#1
There's no built-in batch method to do something like that, it would involve opening each file, selecting by some criteria and deleting, or inserting a block (which adds complexity because of insertion location) but AutoIT could do the opening and closing, and automate a keyboard sequence to invoke a macro, for example.  Not easy, as in magical, to set up.

Logged


* September 02, 2015, 09:18:10 AM
#2
That might still be good enough. Will take a look at it this evening, thanks.

Logged