TurboCAD Forums

The Ultimate Resource for TurboCAD Knowledge

Register
 
The purpose of these forums is to discuss TurboCAD.  Please keep the discussion of other products to compatibility issues or how the other software’s can be used with TurboCAD.


Workplane by Facet
Read 2810 times
* May 24, 2009, 01:08:57 PM
Version 14.2, seemed to have lost the red highlighting of the surface being selected when using workplane by facet.

Am I missing some option selection?

Gary

Logged


* May 24, 2009, 03:58:06 PM
#1
"Auto WorkPlane by Face," which highlights the facet in red (but only when an appropriate tool is selected), was not available until version 15. "WorkPlane by Facet" has been around for a long time, but it highlights the selected facet in GREEN (despite what Help sez). It's not necessary that a drawing tool be active in order to use this option.

Henry H

Logged


May 24, 2009, 04:07:39 PM
#2
Henry,

It's good to see you posting here... where have you been all these days... I've missed you since the old forum...

 ;)

Mike...

Logged