TurboCAD Forums

The Ultimate Resource for TurboCAD Knowledge

Register
 
All posts discussing pricing or where to buy TurboCAD will be deleted.

Simple Boat Loft
Read 901 times
* August 18, 2015, 06:06:36 PM
I am trying to do an eval for TC and one of the things we do is boats. We have used TC to create 2D DXF files for the bulkheads and then we normally cut out a 1/6 model and build it, change and build again. I now have a 3D printer and i was going to try doing the hull in sections. Obviously I can print the bulkheads and assemble but I am hoping to find a way to take the bulkheads, set the distances, loft and then print.

I know some have done boats ( I loved the Garvey flat) but I am looking for any guidance from folks who have done this before. I have been using Cubify and I need to see if TC can do this as well.

Thanks

Logged