TurboCAD Forums

The Ultimate Resource for TurboCAD Knowledge

Register
 
When posting a problem be sure to include which version you are using.  Give as much information as possible.  If the problem is with a specific file be sure to attache it to your post.

Re-introduction
Read 1465 times
February 11, 2015, 03:15:31 PM
Hi Team,

It has been sometime since I was here as I have been busy with other things life puts in front of us. This includes getting the house work done after our earthquakes a few years back, only recently we found a huge crack in our living room floor which was over looked by our insurance company. Why? Because they did not think we were telling the truth about it and they did not wish to lift the carpet on a whim! Go figure.

Among other things, I have been busy learning CREO and am slowly getting my head round this.

Only today, I have upped myself from V16 Pro to V21 Pro Platinum with the CAM add-on and am keen as mustard to get my head round the changes!

Anyway, I am back and good to be back.

Logged
CREO 3 and 5
SolidWorks 2017
TC2019 Pro Platinum CADCAM
Hexagon VISI 2020.1 CADCAM
Christchurch, Middle Earth.


* February 11, 2015, 05:43:13 PM
#1
Hi Team,

It has been sometime since I was here as I have been busy with other things life puts in front of us. This includes getting the house work done after our earthquakes a few years back, only recently we found a huge crack in our living room floor which was over looked by our insurance company. Why? Because they did not think we were telling the truth about it and they did not wish to lift the carpet on a whim! Go figure.

Among other things, I have been busy learning CREO and am slowly getting my head round this.

Only today, I have upped myself from V16 Pro to V21 Pro Platinum with the CAM add-on and am keen as mustard to get my head round the changes!

Anyway, I am back and good to be back.

Welcome back Steve,

It's nice to see things are returning to a somewhat normal state in your life. Good luck to you in the future. If you find time, post some of your work, I always found it interesting.

Logged
DonCW
2017 Pro with Light Works Plug in
2018 Platinum
2020 Platinum

Windows 10
There's so much to learn and not much time left to learn it.


* February 11, 2015, 07:01:25 PM
#2
Good to have you back, Steve.

Henry H

Logged


February 11, 2015, 11:05:55 PM
#3
Thanks fellas.

I have been working on some projects but there is IP involved with a few of them so I am not able to show but I am sure I could find something for 'show and tell.'

Logged
CREO 3 and 5
SolidWorks 2017
TC2019 Pro Platinum CADCAM
Hexagon VISI 2020.1 CADCAM
Christchurch, Middle Earth.