TurboCAD Forums

The Ultimate Resource for TurboCAD Knowledge

The purpose of these forums is to discuss TurboCAD.  Please keep the discussion of other products to compatibility issues or how the other software’s can be used with TurboCAD.

Surface Modeling
Read 5215 times
* October 12, 2009, 02:23:51 PM
After reading other posts, I finally can import points using ImportPoints, but I can't do much with them.  In particular, I want to create contours, but that and half the other choices are greyed out all of the time.  I can create triangles, but that's about it.  What's the secret to getting the functionality promised by the add-in?  I'd also like to see the notes and/or z-data adjacent to the points (but preferably on a different layer).  Is that possible?


* October 12, 2009, 02:40:37 PM
Hi, the key is to have a set of triangles set as the "active surface" then all will be ungreyed.
To create the triangles, just select your points and click "create triangles."

If you have a free Yugma account then I can demenstrate.

I will create a movie and post it soon.

Best Regards,
Jerry Simington