TurboCAD Forums

The Ultimate Resource for TurboCAD Knowledge

The purpose of these forums is to discuss TurboCAD.  Please keep the discussion of other products to compatibility issues or how the other software’s can be used with TurboCAD.

Please help with 3D
Read 1707 times
* October 09, 2009, 08:35:13 PM
Hi guys/gals.
I am fairly new to Turbocad and have never really tried 3D before now.
I am trying to draw a crude layout of a shop my Father-in-Law is currently building. I would like to draw in some shelves, cabinets, and other equipment on certain walls. My trouble is, I am not sure how I can view one wall without looking THROUGH the entire shop while in wire frame.
I would really like to view the drawing like I was standing in the center of the shop and looking at each wall.
I think it might lie in a camera setup but I have not been able to get it to work.
I use V14.2 Deluxe

[attachment deleted by admin]


* October 10, 2009, 02:18:53 AM
I don’t think you can while in wire frame. You could use layers, putting each wall on a layer then turn off what you don’t want to see.


* October 10, 2009, 05:24:20 AM
Boy, do I feel stupid. I got so caught up in trying 3D that I completely blanked on that one. Thanks Mike!!!