TurboCAD Forums

The Ultimate Resource for TurboCAD Knowledge

The purpose of these forums is to discuss TurboCAD.  Please keep the discussion of other products to compatibility issues or how the other software’s can be used with TurboCAD.

problem with Ani lab 5.1 64 bit installation
Read 3527 times
* January 14, 2013, 06:19:47 AM
I have just set up my new 64 bit system, and decided to try my animation lab v 5.1, and it installed, but would not work,so uninstalled.  Eventually I found this link on the forum for the 64 bit update of animation lab 5.1 64 bit.


 I installed it, then got the activation code online and activated it, and it accepted the validation and worked okay. My problem now, is that it asks for the code again everytime I start Turbocad v19 64 bit.

Everytime I enter the validation code, it accepts and I can use it again, but as I say it asks for the validation every time I start Turbocad.

My version was the prize from the Turbocad Challenge, and came in the form of a download.

 Any help appreciated.


* January 14, 2013, 06:30:34 AM
An addition to the previous post, I am using Turbocad v19.2 Pro Platinum  build 54.2 on windows 8.


January 14, 2013, 08:29:39 AM
Hi Michael,

I would suggest you contact Rip Fowler, <RFowler@imsidesign.com>, and see if he can help.

Good luck.

Regards Tim

Regards Tim

You can design without engineering, but you cannot engineer without design.
Using Win 10 with Designer 2017-2020 and TurboCAD Pro. Plat. 2018-2020 + Lightworks (64-bit versions) + AnimationLab 5.2.
Windows 10 Pro (1909) 64-bit

January 14, 2013, 11:11:52 AM
Right click the installation software and select "run as administrator". Then install. That should fix it.

TC user since v3. MacMini 5.1. 2.3 GHz. 16 Gig RAM.
TC 19 Pro 64 bit. Windows 7.

* January 15, 2013, 05:48:54 AM
Thanks for the feedback Tim and Mike, I will give your suggestion a try Mike!.