TurboCAD Forums

The Ultimate Resource for TurboCAD Knowledge

Be sure your post is relevant to the current discussion.  Create a new topic within the appropriate board if you are unsure.

2D Drafting Question - Rectangles/Filled Polylines
Read 1291 times
September 20, 2012, 12:25:02 PM
Using v18.2 pro:

Can a rectangle's sides have varied pen widths? I often have abutting rectangles (filled white) where I want the joint to be a thin line.

I tried the "edit tool" with no luck.


v19.2 Deluxe

* September 20, 2012, 05:05:49 PM
It's possible but awkward. Much easier to explode the rectangle into individual line segments and edit them.

Henry H


* September 21, 2012, 12:29:04 AM
And collect them in a group if the profile should be used serveral times inside the drawing.
Or even better, use constraints or make a ppm in the ppEditor if it's used a lot with variable size

« Last Edit: September 21, 2012, 01:02:04 AM by torfinn »

V20, V21, 2015/ 16/ 17/ 18/ 19 Pro. Platinum
Deluxe 2015/ 16/ 19
RedSDK enabled
Windows 10 Home Premium 64 bit, 32 GB
NVIDIA Geforce GTX 780m, 1 GB