TurboCAD Forums

The Ultimate Resource for TurboCAD Knowledge

The purpose of these forums is to discuss TurboCAD.  Please keep the discussion of other products to compatibility issues or how the other software’s can be used with TurboCAD.

Read 1781 times
* September 14, 2009, 08:02:30 AM
     What is the correct way to get the dimension in a drawing?
If I have a square and look for “H” and   â€œW”
1)   do I use the  “SEKE” keys I or V and then pick a line, or
2)    You use the snap version “S’?
If I use 1) I will get a different dim. then when I use 2)
.090” the correct dimension with ‘I’ or ‘V’
.100” With the “S” version.


* September 14, 2009, 08:56:34 AM
I generally "V" snap to each end of the line I wish to dimension. Another method is to enable Segment Dimensioning, in which case it is necessary only to select the line to be dimensioned.

Henry H