TurboCAD Forums

The Ultimate Resource for TurboCAD Knowledge

Register
 
Be sure your post is relevant to the current discussion.  Create a new topic within the appropriate board if you are unsure.

Colour Palette Missing
Read 2732 times
* August 13, 2009, 03:08:19 PM
Should you not beable to select the Fill Colour from the properies bar ?

You just can select the "SOLID" but no colour paleete is pitching there - after.

Must you go to the colour palletee each ti,me after you want a fill coloutr ?

 TX

[attachment deleted by admin]

Logged


* August 13, 2009, 03:42:04 PM
#1
This may help.
Go to "Tools / Customize" — Commands page.
Scroll down the Categories list to "Property Controls" (next to last).
Click on "Brush Color" and drag-n-drop the command onto the Property toolbar.
Now you can apply a Brush pattern and then a Color without going far.

I believe this tool is only available in the New UI.
The old UI has to do this the olde way.


Logged
John R.

V17—V21, 2015—2019
Designer, Deluxe, (Professional, Expert, Basic), Platinum
RedSDK enabled
Windows 10 Pro (1903), 64-bit


* August 13, 2009, 03:55:40 PM
#2
John

I did as you said - but it do not want to "drag" over - nothing and show only a "cross" mark/

Logged


* August 13, 2009, 04:03:06 PM
#3
I did as you said - but it do not want to "drag" over - nothing and show only a "cross" mark/

Try dropping it onto the Property toolbar. Dropping it between the Brush Pattern and Line Width fields would be a good candidate. Once you drag it over the toolbar, the command should change from an X to a +.


Logged
John R.

V17—V21, 2015—2019
Designer, Deluxe, (Professional, Expert, Basic), Platinum
RedSDK enabled
Windows 10 Pro (1903), 64-bit


* August 14, 2009, 07:20:35 AM
#4
John

Tx - it worked and did the trick - Tx so much, it is a production time saver like heck - Brilliant.

BTW - can you ask for a "Purge" and "Copy in Place" demand also - PLSE !
( BCI Tool one let the V16 not work well and I had to uninstall it )

Those are big time savers also.

Regards

Logged


* August 14, 2009, 12:56:00 PM
#5
BTW - can you ask for a "Purge" and "Copy in Place" command also - PLSE !

There's already a topic in the Wish List section for Purge: Purge topic. Add your name to the list.

I haven't noticed anything wrong with BCiTool's "Copy in Place" tool in V16 under XP Pro or Vista 64.

I have no "pull" as to what is done with the program. Occasionally I can write a good description (along with some pix) to get a point across, but it's all up to Royal, Dave and crew as to what goes into the program. 


Logged
John R.

V17—V21, 2015—2019
Designer, Deluxe, (Professional, Expert, Basic), Platinum
RedSDK enabled
Windows 10 Pro (1903), 64-bit