TurboCAD Forums

The Ultimate Resource for TurboCAD Knowledge

When replying to a specific statement be sure to quote the previous post.

Read 1716 times
* August 12, 2009, 08:34:45 PM
I had a site/floor plan in model space.Then I run file-page setup wizard.
After I saved setting and clicked finish the model screen went blank.
Is there a way to scan model space to see what  (and where ) or if there is anything in given model?
I think I am doing something backwards.

Thank you


* August 12, 2009, 10:30:20 PM

The way I know is to click on "Zoom to extents", which icon is a sheet with arrows each side or press Ctrl-Backspace.

The other alternative is to look out to any layer turned off (remember never to turn Layer 0 off). Turn them all on and press Ctrl-A (select all) and chose in the menu View / Selection info in the Palettes section.
Any object available will appear in that section.

I truly hope you will have success with that.

Stephane Faucher

* August 12, 2009, 10:47:18 PM
Thank you

That's it. Zoom Extents