TurboCAD Forums

The Ultimate Resource for TurboCAD Knowledge

Register
 
When posting a problem be sure to include which version you are using.  Give as much information as possible.  If the problem is with a specific file be sure to attache it to your post.

How Can This Be Done ?
Read 3572 times
* August 06, 2009, 10:51:32 PM
How can the "Pink" Part be adapted to be attached to the "Blue & Taperd Black" part.

Any advice will be welcome.

Tx

[attachment deleted by admin]

Logged


* August 06, 2009, 11:42:40 PM
#1
Care to post as V15 to canvass a wider range of opinion?

Logged


* August 07, 2009, 02:43:20 AM
#2
Care to post as V15 to canvass a wider range of opinion?

Here ya go Murray. :-)

I'm not sure what is being asked here. It looks attached already.

[attachment deleted by admin]

Logged
John R.

V17—V21, 2015—2019
Designer, Deluxe, (Professional, Expert, Basic), Platinum
RedSDK enabled
Windows 10 Pro (1803), 64-bit


* August 07, 2009, 06:19:39 AM
#3
Ta John!   I agree, I don't understand what's being asked.  Triplex, want to give us more to work with?  Blends, booleans, cyanoacrylate?

Logged


* August 07, 2009, 08:54:42 AM
#4
Hi - Pardon for not given more details.

I am trying to figure out how to get the edges of the Pink solid that is bordering the Blue  & Black solids on the same level via a Press Load / or a typo of mitred edge. The rear must stay at the same level.

Tx

Logged


* August 07, 2009, 04:19:38 PM
#5
If I understand correctly, you want drop the top part of the magenta object down so it meets the other two objects. Pressure Load won't do that. Deform To Point might, but you have to increase the parameters considerably; say 50 for Resolution. I tried with the constraint points in various areas, but had no luck. I didn't get anywhere with the Chamfer Edges tool either. Maybe Subtract something out of there.

If you need to bring the bottom up, you can use the Facet Edit tool to rotate that face. You will need to move its Reference Point to an edge before rotating.


Would the Terrain tool or the 3D Mesh tool be a better candidate to make the magenta object? I think they would be easier to control.

Logged
John R.

V17—V21, 2015—2019
Designer, Deluxe, (Professional, Expert, Basic), Platinum
RedSDK enabled
Windows 10 Pro (1803), 64-bit


* August 07, 2009, 09:34:04 PM
#6
How?

[attachment deleted by admin]

Logged


* August 08, 2009, 10:29:33 AM
#7
I've left the mismatch of part of the blue object undone.  It could be done by modifying one of the blue facets, applying a tapered blend along the edge of the magenta body, or a couple of other ways.

[attachment deleted by admin]

Logged


* August 08, 2009, 07:53:34 PM
#8
Here's another. This time the magenta object is a single legitimate Solid. (The magenta object in the pic I posted earlier was actually several sheet objects -- i.e., zero-thickness shells.)

Henry H

[attachment deleted by admin]
« Last Edit: August 08, 2009, 07:58:12 PM by Henry Hubich »

Logged


* August 09, 2009, 12:01:52 AM
#9
Tx Guys

This is really to be appreciatted - all the help

Tx for showing the way.

Logged