TurboCAD Forums

The Ultimate Resource for TurboCAD Knowledge

The purpose of these forums is to discuss TurboCAD.  Please keep the discussion of other products to compatibility issues or how the other software’s can be used with TurboCAD.

subscript out of range error using Ver16.2 mech (revised)
Read 3603 times
March 04, 2010, 11:49:08 AM
  I have used the SDK Sample 3d bolt provided with Ver. 16.2 mech. as an add on, with success however when I try to make it into a 4-40 slotted bolt. I get the error message "subscript out of range", and then a crash when I try to select the bit of the bolt that remains after the error message.  Is it me? or is it a bug?

« Last Edit: March 18, 2010, 06:44:20 AM by Gammaman »


* March 18, 2010, 10:57:50 AM
Hi Gammaman,

When you installed TC, did you do a full install or a custom install? If you didn't do a full install, maybe some of the pieces the Bolt tool requires didn't get installed. You might try changing the installation (Control Panel/Add or Remove Programs) to be sure all the features are present, or a repair on the installation.

If that doesn't solve it, tell me what exact steps you are taking, and any values you are entering so I can try to reproduce the problem.