TurboCAD Forums

The Ultimate Resource for TurboCAD Knowledge

Register
 
Be sure your post is relevant to the current discussion.  Create a new topic within the appropriate board if you are unsure.

more thread 3D weirdness
Read 97 times
* May 21, 2020, 02:17:08 PM
I'm at the point where I can use the thread 3D tool OK, mostly just need to be patient and wait.

I've abandoned the LTE workspace and dynamic input because it's too problematic.

So, with the default workspace and ribbon interface I now use the standard inspector bar. When using thread 3D, the inspector bar has the options to select round, Hex, or square head. The problem for me is, the icons are not appropriate for the task. The popup is OK, just not the icons.

Anyone else see this?

Joel

Logged


* May 21, 2020, 02:33:42 PM
#1
Confirm.

Tim Stewart reported this at the beginning of May, but I haven't seen any feedback from management.

V27.0.19.6 (64-bit) Platinum

Logged
John R.

V17—V21, 2015—2020
Designer, Deluxe, (Basic, Expert, Professional), Platinum
RedSDK enabled
Windows 10 Pro (1909), 64-bit