TurboCAD Forums

The Ultimate Resource for TurboCAD Knowledge

When posting a problem be sure to include which version you are using.  Give as much information as possible.  If the problem is with a specific file be sure to attache it to your post.

Cursor location problem
Read 629 times
* February 28, 2019, 06:48:51 PM
I  just upgraded to Turbocad Deluxe 2018. When I select any item in my drawing the Y location is 225 inches higher than the location of the cursor. The x location is OK. Why would that be and can I get them lined up. I don't think it was that way when I first started the drawing.


* February 28, 2019, 07:40:28 PM
Where are you reading the location of the selected item and of the cursor?

Henry H


* February 28, 2019, 08:50:17 PM
 2D or 3D drawing ?

At a guess, you have a Workplane issue.

Save the File with a Different name (keep the original file)

Make the Workplane visible ... then Revolve the Drawing to see it's orientation.
If it's messed up, then Reset Workplane via World .... or Set Workplane via 3 Points on a Flat 2D object >> Then Select all and "Place on Work Plane"