TurboCAD Forums

The Ultimate Resource for TurboCAD Knowledge

Register
 
Be sure your post is relevant to the current discussion.  Create a new topic within the appropriate board if you are unsure.

Strange behaviour with extrude
Read 725 times
February 04, 2019, 05:28:59 PM
Im getting strange behaviour from this 3D polyline where It was originally derived from a spline and and one polyline joined together. When I try to extrude in the general facet direction it creates a weird extrude which is vertical.

Logged
Daz
TCW V21, 2015-2020 PP, Animation Lab V5.2 & Redsdk enabled, LightWorks rendering mostly. Ender 3 3D printer.


* February 04, 2019, 06:23:30 PM
#1
A 3D Polyline extrudes in the Z direction of its own Workplane.

Henry H


Logged


February 04, 2019, 06:29:46 PM
#2
Thanks Henry after further investigation I found that the two objects where on different planes as one object was slightly rotated and could not get them to join for extruding.

Logged
Daz
TCW V21, 2015-2020 PP, Animation Lab V5.2 & Redsdk enabled, LightWorks rendering mostly. Ender 3 3D printer.