TurboCAD Forums

The Ultimate Resource for TurboCAD Knowledge

Register
 
The purpose of these forums is to discuss TurboCAD.  Please keep the discussion of other products to compatibility issues or how the other software’s can be used with TurboCAD.


New Snap tool "Midpoint between 2 Points"
Read 517 times
* October 27, 2018, 02:25:23 AM
Issue: New Snap tool "Midpoint between 2 Points" does not appear in dialog after right-clicking on SNAP in status bar

Comment: "Mid 2 point" is TurboCAD tool. Same as "Line" tool for example. So it shouldn't appear in this place.

Logged


* November 07, 2018, 02:20:40 PM
#1
The "Mid 2 Points Snap" tool is found in the main part of the "Modes" Menu. It can also be found by itself in a "Custom" toolbar.

You can go to the "Commands" page of the "Customize" dialog and drag the tool out from the "Modes" category to a Menu/Toolbar of your choosing.

Logged
John R.

V17—V21, 2015—2019
Designer, Deluxe, (Professional, Expert, Basic), Platinum
RedSDK enabled
Windows 10 Pro (1803), 64-bit