TurboCAD Forums

The Ultimate Resource for TurboCAD Knowledge

The purpose of these forums is to discuss TurboCAD.  Please keep the discussion of other products to compatibility issues or how the other software’s can be used with TurboCAD.

New Learner
Read 617 times
* October 21, 2018, 04:35:47 PM
Hi all, Have just installed Turbo Deluxe 2018. I'm now retired but I did use Turbocad V6.5 on Win NT for drawing Pipeline schematics.
 So bear with me If I ask some dumb questions. The first one is "How do I stop Turbocad Pro & other builds from popping up on startup ?. I have been ticking the box "Do not show again" but it always comes back. I have also unticked the TC start in setup.
 The program also takes a long time to start.

Any suggestions


* October 21, 2018, 05:04:41 PM

Does This thread help.  it sounds like a similar problem.


* October 21, 2018, 07:07:27 PM
Thanks Andy, I followed the instructions & now OK