TurboCAD Forums

The Ultimate Resource for TurboCAD Knowledge

Register
 
The purpose of these forums is to discuss TurboCAD.  Please keep the discussion of other products to compatibility issues or how the other software’s can be used with TurboCAD.


Cannot see my cursor?
Read 613 times
* August 04, 2018, 02:32:12 PM
After getting a previous issue somewhat resolved.  Now I can not see my cursor.  Or, snap aperture, or preview when drawing a line?  any ideas?

Logged
TuboCad Deluxe 2017. 
Newbie, but Getting There.


* August 04, 2018, 08:23:31 PM
#1

Logged
-----------------------------------------------------------------------------------
Very low knowledge of English - I ask for indulgence - Thanks
Currently installed
TurboCAD  Professional 32-bit V.17.2.77.1
TurboCAD 2016 ProPlatinum 64-bit V23.2-61.2 engl.
TurboCAD 2015 2D V.22.2.51.4
on Win 10.


* August 11, 2018, 07:30:16 AM
#2
Well, I sort of fixed it.  by looking at the links you provided.  I can see my cursor in wireframe now.  Still not in in any kind of render mode.  Also, render mode is not a very good quality.    It asks to turn on RedSDK when I start a drawing. My Graphics card is supported, it says.  But, if I do, the software is un-useable.  Any other ideas?  I was thinking of upgrading to 2018, but, I am having second thoughts.  Not going to upgrade to the same issues.   I have used 2017 for some time, with no issues, now this.  And, I cant figure out why.  Any ideas, suggestions would be greatly appreciated.

Logged
TuboCad Deluxe 2017. 
Newbie, but Getting There.


* August 12, 2018, 10:09:23 AM
#3
Well, I am going to give a TC2018 a trial run before purchasing.  Hopefully, it will work better than what I have?  Not blaming the software, I am just a novice user, and having a hard time with all the perameters, I think. 

Logged
TuboCad Deluxe 2017. 
Newbie, but Getting There.