Is it possible to reverse the round bevel.in a solid. I seem to remember in one of Dons Tut he reversed the round bevel .I cannot find it in the manual. I am using 21 with windows ten  NJR

Like this ...?

Henry H

I believe Don used the Quick Pull tool with the "Detect Blend Network" active. Click on the blended portion, then pull it out or enter zero in the Inspector Bar.

Is it possible to reverse the round bevel.in a solid. I seem to remember in one of Dons Tut he reversed the round bevel .I cannot find it in the manual. I am using 21 with windows ten  NJR

Neville, I should have asked this earlier: What do you mean by "reverse" the bevel?

Henry H

Henry You have covered it in Fillet the reentrant edge. But i am sorry i do not know how to do this.Thanking you neville

Henry You have covered it in Fillet the reentrant edge. But i am sorry i do not know how to do this.Thanking you neville

Neville, just activate the Fillet Edges tool and click on the reentrant edge, then click the "Finish" icon on the Inspector Bar. See attached screenshot.

Henry H

Henry I have been expecting too much. I thought I could just reverse the bevel and it would curve in instead of out. But now I know what I have to do thank you once again
Neville. I found what Don did but it was for a bevel with two different sizes you use ctrl when doing it.

Henry I have been expecting too much. I thought I could just reverse the bevel and it would curve in instead of out. But now I know what I have to do thank you once again
Neville. I found what Don did but it was for a bevel with two different sizes you use ctrl when doing it.

I don't know how to do that easily, but that doesn't mean it can't be done.

Henry H