TurboCAD Forums

The Ultimate Resource for TurboCAD Knowledge

Register
 
The purpose of these forums is to discuss TurboCAD.  Please keep the discussion of other products to compatibility issues or how the other software’s can be used with TurboCAD.


Get a better understanding on these tests
Read 653 times
* May 07, 2018, 04:11:26 PM
Hi All, just want to get some feedback and clarity on the following testing:

Summaries
Four point bend tests were performed on samples in 3 categories:
Tubes ( serve as baseline geometry )
Samples without weaves
Sample with weaves

Advantages
Light weight
Normalized bending stiffness ( rigidity ) on par with tubes of similar mass
Weaved sample has much higher buckling load by restricting the buckle to occur at higher modes, thus higher loads
Energy absorbing of the designed structure is much better than the tubes.

Improvements
Varying and controlling pretension in weaves for increasing the normalized bending stiffness
« Last Edit: May 07, 2018, 04:13:02 PM by Darryl W »

Logged
Daz
TCW V21, 2015-2019 PP, Animation Lab V5.2 & Redsdk enabled, LightWorks rendering mostly.


May 09, 2018, 02:47:31 AM
#1
Uhmm... I'm confused.  I have never seen any 'weaves' in TurboCAD.

Reads as if you are talking about real world stuff.


Jeff

Logged
TC Pro Platinum 2019, 2018, 2017, 2016 & 2015 (all with LightWorks & RedSDK) & V21
System: i7-5820K @ 3.30GHz, ASRock X99 Extreme4, 16GB DDR4-2133 RAM, Gigabyte GTX 970, Samsung NVMe SSD 950 (256GB), Windows 7 Pro (64-bit) SP1