TurboCAD Forums

The Ultimate Resource for TurboCAD Knowledge

Register
 
Be sure your post is relevant to the current discussion.  Create a new topic within the appropriate board if you are unsure.

Simple Bearing Animation
Read 1532 times
* December 28, 2017, 07:00:01 PM
A simple animation based of Don Cheke's Ball Bearing video, thanks Don!

Logged
Daz
TCW V21, 2015-2019 PP, Animation Lab V5.2 & Redsdk enabled, LightWorks rendering mostly.


* December 28, 2017, 11:09:43 PM
#1
Very Nicely done Darryl,  your getting good at rendering  :)

Logged


December 29, 2017, 03:07:20 AM
#2
Hi Daz,

    nice render.  I'm sure Don would be impressed.

    May I suggest holding the outer ring, whilst slowly rotating the inner parts, in a continuous loop?

Regards Tim

Logged
You can design without engineering, but you cannot engineer without design.
Using Win 10 with Designer 2016/2017 and TurboCAD Pro. Plat. 2018/2019 + Lightworks (64-bit versions) + AnimationLab 5.2.


* December 30, 2017, 02:22:01 PM
#3
Tim, yep understood. There a 3 parts to this animation and what Ive posted is part1.

Logged
Daz
TCW V21, 2015-2019 PP, Animation Lab V5.2 & Redsdk enabled, LightWorks rendering mostly.