TurboCAD Forums

The Ultimate Resource for TurboCAD Knowledge

Be sure your post is relevant to the current discussion.  Create a new topic within the appropriate board if you are unsure.

how to measure dimansion
Read 1024 times
* November 12, 2017, 11:58:18 PM
How can I measure dimension from the end to midpoint of a line? it doesnt snap anything although i have snap turned on
all i want to do is to measure dimension from midpoint to end point of a line !. this is all !

« Last Edit: November 13, 2017, 12:11:18 AM by ketanco »

I use Turbocad Designer 2015

* November 13, 2017, 01:06:58 AM
This is from Designer 2016 but guess it is the same in 2015.
Click on the Snap"mouse", hold just a little time so that the menu open and make sure the Middlepoint is checked, then move the cursor to about middle on the line, leftclick and it should find the middlepoint, i normally use the SEKE, then i select the dimensiontool, move the cursor to the line and press M(middlepoint), and then the next point in the end of the line, press V(vertex).
Also make sure that the SNAP down on Inspector Bar is not greyed out as this turn of all snap's too.


V20, V21, 2015/ 16/ 17/ 18/ 19 Pro. Platinum
Deluxe 2015/ 16/ 19
RedSDK enabled
Windows 10 Home Premium 64 bit, 32 GB
NVIDIA Geforce GTX 780m, 1 GB