TurboCAD Forums

The Ultimate Resource for TurboCAD Knowledge

Be sure your post is relevant to the current discussion.  Create a new topic within the appropriate board if you are unsure.

corrupt spline
Read 1046 times
* June 27, 2017, 08:07:29 PM
Of all the complicated tools in TC 2017, I hadn't expected the humble spline to become corrupt,   I struggled to decide why this would not loft nor extrude with compound profile, until I used make copy on the spline, moved the copy to one side and used place on workplane on the copy, yep, does look a bit corrupt (this spline was a scaled copy of another one, making the scaled copy was probably what corrupted it).

Tip - If this happens to anyone else, don't waste time trying to repair, use show frame in the spline - curve properties, and snap a new spline by control points to the vertices of the frame, delete the bad one.. 

« Last Edit: June 27, 2017, 08:24:53 PM by Andy H »