TurboCAD Forums

The Ultimate Resource for TurboCAD Knowledge

When replying to a specific statement be sure to quote the previous post.

Polyline does not Extrude
Read 1547 times
* May 22, 2017, 11:58:44 AM
It is most commonly reported that polyline does not extrude to create a 3D solid, rather it creates a hollow closed entity with the height as set for extrude.

This happens when the end points of a closed polyline shape are not joined properly, either there is a gap or one of the segments extends the intersections point. So, if this happens, then trim that segment and use close profile to draw a closed profile, to make sure that the end points of the polyline meet at one point.